Surfboard RUSTY ACT Moby Fish 6.8 Quad

In 2005 I made my first 4 fin Moby. I really liked the feel of this ride. I had ridden it in surf up to approximately 5 foot. One day I thought the surf was pretty small, so I took my Moby down to Blacks. Nothing else. I was very fortunate to have a key. When I got to the bottom of the road, the surf looked as I thought it would. Pretty small but clean. I put on my wetsuit, pulled the Moby out of the back of my truck, closed the hatch. I looked out at the lineup and did a double take. A solid 6-foot set. Fu#k! Well, it was the only board I had with me, so off I went.
My first wave, I was trippen, because I thought I would really have to pull back on the reigns. No. The board took off like a bat out of hell. It had no top end. After a few more waves, I was completely sold on this design and the versatility it had.
It's been very popular, some of my good friends had them. What was interesting, their sons, some of the best LJ reef surfers, tried them and didn't want to give them back. They ordered duplicates. Not smaller, leaner versions. The same boards. They actually rode them on the bigger days.
Because of it's size, it is a great board for beginners and is a great alternative to a longboard. As it turns out, it's good for all ranges of ability and surf. The entry rocker is relaxed which helps with the paddle. The exit rocker is on the average plus side which helps with turning and fits into the waves better. The fuller outline provides lots of surface area: glide and speed. The rails are fuller but somewhat angular with a lower apex providing lift and control.
I were relegated to one board, this would be it. Fun.

Dimensions: 6.8 x 21,38 x 2.59 - 42,4 Liter
4 Fin Ouad Setup, fitting Futures Fins

Content: Board without fins

ACT PREPREG Cronstruction
Torq ACT surfboards are the world's first EPS/Epoxy Pre-Preg surfboards. The technological advantages are immense, but the most significant advantage is 100% controlled process with ZERO surplus resin. On any surfboard the resin's function is to hold the fibre in place. It offers little structural integrity of it's own, little flex and little impact strength. As a material without the fibre it is heavy and brittle. Any surplus resin is dead weight - resisting flex, adding weight. With Pre-Preg process the perfect amount of resin is added to the cloth by machine, before the shaped blank is laid up - zero surplus, zero dead weight.

---